Analysis of Tube Design for Clean Water from Stainless Steel 304 and 201
Analisa Desain Rancangan Tabung untuk Air Bersih dari Bahan Stainless Steel 304 dan 201
-
(1) * Muhammad Amin Putro
Universitas Muhammadiyah Sidoarjo
Indonesia
(2) Prantasi Harmi Tjahjanti Universitas Muhammadiyah Sidoarjo
Indonesia
(*) Corresponding Author
Abstract
This study aims to design the water tube for pure water namely a set of processing tools used to place the water using Autodesk Inventor 2016 software. The data which inputted is stainless steel SS 304 and SS 201, because both of them have the Cr and Ni elements, which will be used as tubes and the top and bottom caps. The results of running data are von mises stress, displacement, and safety factor. The output data were used to obtain the most efficient material and thickness variations between 1.5mm, 2mm, and 3mm. The most suitable and efficient result shown at 3mm thick SS 304 with the maximum value of von mises stress is 14.62 MPa, a maximum displacement of 0.013mm, and a safety factor of 15.
Downloads
References
Muliawan, “Metoda Pengurangan Zat Besi Dan Mangan Menggunakan Filter Bertingkat Dengan Penambahan UV Sterilizer Skala Rumah Tangga,” J. Ilm. Giga, vol. 19, no. 1, pp. 1–8, 2016.
W. Kristiyanti, “Perancangan Tabung Penyaring Penjernih Air,” J. Apl. dan Rekayasa Dalam Bid. Iptek Nukl., vol. 5, 2008.
R. DAMAS, “No Title سلطنة عمانペインクリニック学会治療指針２,” ペインクリニック学会治療指針２, vol. 4, no. 1, pp. 75–84, 2019, doi: .1037//0033-2909.I26.1.78.
B. Setyono, “Perancangan Dan Analisis Kekuatan Frame Sepeda Hibrid ‘Trisona’ Menggunakan Software Autodesk Inventor,” J. IPTEK, vol. 20, no. 2, p. 37, 2016, doi: 10.31284/j.iptek.2016.v20i2.43.
