Monitoring of Fuel Height Gauge at IoT-Based Gas Stations
Monitoring Pengukur Tinggi BBM Pada Tandon SPBU Berbasis IoT
-
(1) * Nuril Alawi
Universitas Muhammadiyah Sidoarjo
Indonesia
(2) indah sulistiyowati Universitas Muhammadiyah Sidoarjo
Indonesia
(*) Corresponding Author
Abstract
The increasing number of motor vehicles has been increasing the fuel demands, especially the demands for ‘pertalite’ (product of fuel) and ‘pertamax’ (product of fuel) fuels. These fuels are usually placed in a cylindrical reservoir at an SPBU (gas station) that is located below the ground surface. To find out the remaining volume of BBM (fuel), gas station attendants usually check it manually by dipping the meter stick to the bottom of the reservoir. Then, the boundary surface of the fuel is used as a reference in reading the meter value. Because it was considered to be an ineffective measurement, an Android-based electronic media was created to make it easier. This tool uses the HC-SR04 ultrasonic sensor to detect the fuel height level in the reservoir. To show the results, the Blynk application is applied for the user interface. To support the IoT (internet of things) system, NodeMCU is used that is included with the WIFI module so that it can be connected to the internet. Based on the tests that have been done, the HC-SR04 ultrasound sensor has good accuracy and can monitor the height levels of fuel in real-time.
Downloads
References
B. P. Statistik, “Perkembangan Kendaraan Bermotor,” Sidoarjo, 2017.
Viki Zola Putra, “Rancang Bangun Alat Ukur Ketinggian Bensin Di Dalam Reservoir SPBU Dengan Sensor Ultrasonik,” Universitas Andalas, 2011.
R. R. A. Siregar and R. Raymond, “MODEL SISTEM MONITORING TANGKI BAHAN WEB APLIKASI DAN SMS GATEWAY,” JETri, vol. 12, pp. 59–72, 2015.
FITROH MERKURI WANDANI, “RANCANG BANGUN PROTOTIPE SISTEM MONITORING TANGKI PENDAM SPBU BERBASIS NODEMCU DAN INTERNET OF THINGS ( IoT ),” UNIVERSITAS ISLAM NEGRI SUNAN KALIJAGA YOGYAKARTA, 2017.
M. Sudrajat, T. D. Rachmildha, N. Ismail, and E. A. Z. Hamidi, “Prototipe Sistem Monitoring Air Pada Tangki Berbasis Internet of Things Menggunakan NodeMCU Esp8266 Dan,” SENTER, no. 2016, pp. 15–16, 2017.
N. S. S. AGUSTINE, “SISTEM MONITORING AIR PADA RESERVOIR PDAM JEMBER MENGGUNAKAN SENSOR ULTRASONIK DAN WATER FLOW,” UNIVERSITAS JEMBER, 2016.
A. Najmurrokhman and A. M. Annas, “Perancangan Instrumen Pengukur Ketinggian Menggunakan Sensor Adxl345 Yang Terkoneksi Dengan Smartphone Berbasis Android,” 2015.
Afif Muhammad Khoiruddin, “PENGEMBANGAN ALAT UKUR TINGGI BADAN DAN BERAT BADAN DIGITAL YANG TERINTEGRASI,” Universitas Negri Yogyakarta, 2015.
M. A. SUTIONO, “RANCANG BANGUN SMART RICE COOKER MENGGUNAKAN PROTOKOL KOMUNIKASI WI-FI DAN PROTOKOL PERTUKARAN PESAN MQTT,” UNIVERSITAS MULTIMEDIA NUSANTARA, 2016.
Y. SETIAWAN, “RANCANG BANGUN PEMANTAUAN DAN PENJADWALAN ALAT PEMBERI PAKAN IKAN OTOMATIS SECARA JARAK JAUH,” INSTITUT BISNIS DAN INFORMATIKA STIKOM SURABAYA, 2017.
H. NURADA, “Naskah publikasi sistem informasi teknik elektro berbasis android di universitas muhammadiyah surakarta,” 2014.
D. Janto, “SISTEM INFORMASI PERKEMBANGAN BALITA BERBASIS ANDROID Skripsi,” p. 115, 2016.
dwi janto, “sistem informasi perkembagan balita berbasis android,” universitas negeri semarang, 2016.
S. K. M. K. Arafat, “SISTEM PENGAMANAN PINTU RUMAH BERBASIS Internet Of Things ( IoT ) Dengan ESP8266, 2016. DOI: https://doi.org/10.31602/tji.v7i4.661
